Some days ago one of the leds of the OSC knob stop working and now I don't know what to do. It's under warranty but I don't want to send it to service just for a single led.
So the question is... Has anybody tried to replace some malfunction led?
Led replacement
Malfunction LEDs are really rare these days.
So maybe there is only a soldering bad.
So maybe there is only a soldering bad.
keep on turning these Moog knobs
Sequence:
Prodigy * minimoog '79 * Voyager * MF102 * MF103 * MF104z * MP201 * Taurus 3 * Minitaur * Sub Phatty * MF105 * Minimoog 2017+ MUSE * One 16
Sequence:
Prodigy * minimoog '79 * Voyager * MF102 * MF103 * MF104z * MP201 * Taurus 3 * Minitaur * Sub Phatty * MF105 * Minimoog 2017+ MUSE * One 16
The same happened to my LP a while ago. It's one of the LEDs around the Env-knob that has stopped glowing (or at least glows much less brightly)...
It feels silly to send away the entire synth for such a small thing, but it also feels bad to have my precious Phatty in a severed state when it's still under warranty.
Have you had any contact with Moog about it?
It feels silly to send away the entire synth for such a small thing, but it also feels bad to have my precious Phatty in a severed state when it's still under warranty.
Have you had any contact with Moog about it?
I started by emailing Moog, but got no response...
So I eventually contacted the store where I bought the synth. They contacted the distributor, who said that I shall send it to them as soon as they get the spare parts. And then they'll fix it for me.
I hope that it will be soon, since it's only under warranty for about a month more...
So I eventually contacted the store where I bought the synth. They contacted the distributor, who said that I shall send it to them as soon as they get the spare parts. And then they'll fix it for me.
I hope that it will be soon, since it's only under warranty for about a month more...
Some days ago I e-mailed the distributor in Spain asking if the solution was easy to perform. I was suggested not to do it and to send it to repair (for free since it's under warranty) because it was hard to do it. They told me a special piece (?) is needed to change the led.
I didn't start this post to complain about anything, just to find a solution. Though I'm quite dissapointed with the overall quality (without onsidering the sound of course). I had to send it to repair because a key was not working, my unit has some minor cosmetic flaws on the wood panels, now a led... :'(
But, at least... It SOUNDS
I didn't start this post to complain about anything, just to find a solution. Though I'm quite dissapointed with the overall quality (without onsidering the sound of course). I had to send it to repair because a key was not working, my unit has some minor cosmetic flaws on the wood panels, now a led... :'(
But, at least... It SOUNDS