Moog Music Forum

Hey there, while playing through an Arpeggiator, I noticed that my Voyager Select Series doesn't put out a Velocity of 0 when releasing keys. It is always at least '1'. Sample output of the MIDI data sent from my Voyager: 19:28:19.063 To Session Note On 1 60 1 19:28:19.332 To Session Note Off 1 60 1...

CR8 was indeed faulty. Since I was already in there, I replaced all germanium diodes on that board with SD103A (Shottky) diodes, in case they would fail in the near future as well. (side note: Q12 also was faulty, which I discovered during my troubleshooting) Everything is working fine now. Thank yo...

Thanks for your reply.
Since I already replaced the flip-flop pair (Q15/Q25) I'm going for CR8 and/or CR6 next.
Can you recommend a replacement for the IN34A?

Hey there, so I have this Model D and its volume envelope starts cycling by itself when I turn down loudness sustain below 9 o'clock. This is a really weird issue and I can't find the error. I replaced all the faulty/old capacitors on the contour generator PCB and most of the semiconductors (every 2...

The Rogues VCA is bypassed (i.e. always on) in my picture. Would that change your visualization of the patch? Still working on getting a similar sound on the voyager. Main hindrance so far were a non cycling envelope (solved by setting Filter ENV Trigger: S+H and Env Gate: ON/External) and a non 'al...

Thanks!

Doh, that was obvious.
When you say "to trigger in.", you mean the "Env Gate In" on the backside right?

Thanks!

From the Moog Rogue manual:
"Auto Trigger will trigger the contour generator at each complete cycle of the LFO, when turned "on"."

Is there any way to set this functionality up on a Voyager (+the VX-351)?

Thanks.

Auto trigger is missing, so I guess this isn't possible to recreate on a Voyager.
Opening another thread for this.

From the Rogue manual:
"Auto Trigger will trigger the contour generator at each complete cycle of the LFO, when turned "on"."

Couldn't come up with a cable like you would like to have, but put this in the search engine of your choice: Low Profile Right Angle Adapter, DB25 Male / Female, Cable Exit 3 You have to watch out for the correct cable exit though, so the cable would actually go towards the edge of the VX and not ov...

Great, will try again with your comments in mind and report back.
Thanks!

I had a hunch and just found the MG-1 block diagram:


Is this comparable to the Rogue functionality?

Ok, hard sync or general sound texure aside, focusing on the modulation routing, can I somehow get the same behaviour of the Rogues Modulation to Contour Generator VCA mode?

How can I reproduce this patch on a Voyager? http://i111.photobucket.com/albums/n132/dualmono/misc/th_IMGP7094_zps29faa4d3.jpg The Rogue patch seems trivial to set up on the Voyager, but nevertheless I am struggling with setting this up. Apparently I am unsure about the interaction of the modulation...

Thank you for your help.